Publicité
Les langues disponibles
Les langues disponibles
To avoid
breakage:
Do NOT handle
or manipulate
the unit by the cooktop.
_Thecounter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1)
_Before installing the unit,
measure the heights of
the two (2) cabinet sides
(H1-4), front and back (see
illustration 1) from the floor
to the top of the counter.
Shave Raised
Edge to
Clear Space
for a 311/2"
(81 cm) Wk
Cooktop.
_Level t he range using the four (4)leveling legs so
that the height from the floor to the underside
of the cooktop glass frame is greater than the
tallest cabinet measurement by at least 1/16" (see
illustration 2).
Illustration
1
bSlidethe unit into the cabinet. Make sure the center of the unit is aligned with the center of
the cabinet cut-out.
_Removethe protective channels on each side of the cooktop (if provided).
pThemetal flange under each side of the cooktop MUST be placed over
the cabinet countertop for proper unit support. The cooktop should
NOT rest directly on the countertop (see illustration 2) or else it could
cause damage to the cooktop voiding the warranty. Level the unit if
needed.
_After the installation, MAKE
SUREthat the unit is supported
by the leveling legs and NOT by
the cooktop.
Tosuccessfully
install the range,
•" the initial level
height from floor
to underside of
cooktop frame
should be at
least 1/16"
taller than
cabinet sides
as measured in
step 2.
Illustration
2
3
Publicité
