JVC D-ILA DLA-M15U Manuel D'instructions page 27

Basic Operations
Projector's buttons
STAND BY
OPERATE
LAMP
TEMP
EMERGENCY
VIDEO
COMPUTER
SETTING
+ 3
QUICK
ALIGN.
- 2
Remote control unit
OPERATE
COMPUTER VIDEO
T
VOL.
ZOOM FOCUS
W
MENU/ENTER
PAGE
BACK
PRESET
QUICK AV
ALIGN. MUTING
26
STAND BY indicator
OPERATE indicator
OPERATE button
2, 1
MAIN POWER switch
1, 2
OPERATE button
2, 1
The following describes the basic procedure for normal use of
the projector.
1. Turning on the Power
1 Turn on the MAIN POWER
switch.
ON [ ]:The main power turns on and the STAND BY
indicator comes on.
2 Press the OPERATE button.
(Or press the remote control's
OPERATE button for one second
or more.)
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Remote control unit
OPERATE
Notes
• After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
• If the light-source lamp does not light up, try to press the OPERATE
button again.
(Or, press the OPERATE button on the remote control for more than
a second.)
Turning off the Power
1 Press the OPERATE button.
(Or press the remote control's
OPERATE button for one second
or more.)
Example of the projector's button
(ON)
OPERATE
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
2 Turn off the MAIN POWER switch
after the STAND BY indicator
changes to steady on.
OFF [‡ ‡ ‡ ‡ ‡ ]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). Turn it
off after the STAND BY indicator becomes on (stand-
by mode).
Projector's indicator
STAND BY
(ON)
Projector
(ON)
or
OPERATE
Projector
(Blinking)
\
STAND BY
Projector
(OFF)
STAND BY