Precautions not to damage the appliance
Raw pan bottoms or damaged saucepans (not enamelled cast iron pots,) may damage
the ceramic glass.
Sand or other abrasive materials may damage ceramic glass.
Avoid dropping objects, even little ones, on the vitroceramic.
Do not hit the edges of the glass with saucepans.
Make sure that the ventilation of the appliance works according to the manufacturer's
instructions.
Do not put or leave empty saucepans on the vitroceramic hobs.
Sugar, synthetic materials or aluminium sheets must not contact with the heating
zones. These may cause breaks or other alterations of the vitroceramic glass by
cooling: switch on the appliance and take them immediately out of the hot heating
zone (be careful: do not burn yourself).
Never place any hot container over the control panel.
If a drawer is situated under the embedded appliance, make sure the space between
the content of the drawer and the inferior part of the appliance is large enough (2 cm).
This is essential to guaranty a correct ventilation.
Never put any inflammable object (ex. sprays) into the drawer situated under the
vitroceramic hob. The eventual cutlery drawers must be resistant to heat.
Precautions in case of appliance failure
If a defect is noticed, switch on the appliance and turn off the electrical supplying.
If the ceramic glass is cracked or fissured, you must unplug the appliance and contact
the after sales service.
Repairing has to be done by specialists. Do not open the appliance by yourself.
WARNING: If the surface is cracked, switch off the appliance to avoid the possibility of
electric shock.
Other protections
Note sure that the container pan is always centred on the cooking zone. The bottom
of the pan must have to cover as much as possible the cooking zone.
For the users of pacemaker, the magnetic field could influence its operating. We
recommend getting information to the retailer or of the doctor.
Do not to use aluminium or synthetic material containers: they could melt on still hot
cooking zones.
THE USE OF EITHER POOR QUALITY POT OR ANY INDUCTION ADAPTOR
PLATE FOR NON-MAGNETIC COOKWARE RESULTS IN A WARRANTY BREACH.
IN THIS CASE, THE MANUFACTURER CANNOT BE HELD RESPONSIBLE
FOR ANY DAMAGE CAUSED TO THE HOB AND/OR ITS ENVIRONMENT.
21