Publicité
Les langues disponibles
Les langues disponibles
5. Charging
EN
The scooter is fully charged when the LED on the battery charger changes from red to green.
WARNING!
Only use the original battery charger to avoid potential damage or fire. Switch off the vehicle or into a certain
·
non-operational mode during charging.
Do not charge when the charging port or power cord is wet. If the battery is damaged or soaked with water , it is
·
forbidden to charge or continue to use the battery
+
≤30%
When the scooter is turned off for about a month with the battery level of the scooter being lower than 30%, the
scooter will enter sleep mode. In this case, the scooter cannot be turned on. To exit the sleep mode, charge the
scooter for about three seconds to activate the battery.
09
1. Open the charging
2. Plug the battery
3. After charging, pull
port cover
charger into the
the plug and close the
charging port.
charging port cover
tightly
=
≈ 30
6. Connect with Mi Home/Xiaomi Home App
1. Scan the QR code on the scooter, located on the right
side of the footboard, or on the back cover of the user
manual to download the Mi Home APP.
Note:
· The QR code is unique to your scooter, please keep it safe.
· When connecting the scooter to the Mi Home/Xiaomi Home app, place your phone to the scooter as close as
possible to make sure it is within the effective Bluetooth range.
· If change the account, delete the scooter from the account it is paired with first, then reconnect the scooter with the
Mi Home/Xiaomi Home app.
Reset Bluetooth
Make sure the scooter is turned on. Squeeze the brake lever, and press the power button 5 times to reset. When the
scooter beeps, it has been reset successfully.
Restore Factory Settings
Make sure the scooter is turned on. Squeeze the brake lever, and simultaneously press and hold the power button for
7 seconds. When you hear a beep, the scooter has been restored to factory settings. This operation will completely
delete the data stored in the scooter, please proceed with caution.
Note: The scooter cannot be restored to factory settings during riding or when locked.
2. Open the Mi Home/Xiaomi Home app. Tap "+" on the
top right corner and open "Scan" to scan the QR code
again. Then follow the instructions in the app to add
the scooter.
EN
10
Publicité
