GM 22935726 Instructions D'installation

Buick Enclave Splash Guard - Rear
Please read instructions thoroughly before starting.
Installation Time
Approximately 30 minutes.
Tools Required
T15 Torx Screw Driver
T20 Torx Screw Driver
Drill
13/16" (5.0 mm) Drill Bit
Clean Cloth/Rag
Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
M4.2 x 20 Self-tapping Screw
U-nut
Instruction Sheet
Installation Procedure
1. Remove rear tire.
2. Clean and degrease body panel where splash guards are
to be located.
3. Remove screw from locations (A) and (B) of rear fascia
Retain fasteners. See Fig. 1.
4. Align splash guard to vehicle and reinstall screws at locations
(A) and (B).
5. While holding splash guard firmly against fascia drill 13/64"
(5.0 mm) holes at locations (C) and (D). See Fig. 1.
6. Remove fastener from locations (A) and (B) as well as the
splash guard.
7. Attach U-nuts to fascia (and behind liner) over drilled holes
at (C) and (D) and reposition liner to original location. See
Fig. 2.
8. Align splash guard to fascia and install screws at locations
(A), (B), (C) and (D) while holding the splash guard against
the panel to minimize gaps. See Fig. 3 and Fig. 4.
9. Repeat procedure for the other side.
10. Guards can be cleaned with any commercially available
cleaner.
Buick Enclave Splash Guard - Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 12JL13
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
4
4
1
REVISION
Initial Release - Vinay Saini
FIGURE 1
EXISTING
SCREWS
FIGURE 3
EXISTING
SCREWS
IR 12JL13
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
Buick Enclave Splash Guard - Rear
1891986
PART NO.
DRILL HERE
DRILL
HERE
U-NUTS
SELF-TAPPING SCREW
SELF-TAPPING SCREW
22935726
PART NO.
22935726
VIEW FROM
BELOW
FIGURE 2
FIGURE 4
1 3
SHEET OF
1 3
SHEET OF