Publicité
Les langues disponibles
Les langues disponibles
OneStep™ Personal Eye Wash Station
S19-918, S19-924, S19-925, S19-926, S19-927 and S19-928
Installation Instructions
OneStep™ Installation
1. STATION: Using the three screws and wall anchors
provided, mount the station near the potential eye hazard in
plain view. The station includes three screw holes for
mounting to a solid surface wall.
2. EYEWASH BOTTLE: Remove the pin from the holder
brackets on the station. While holding bottle, align the cap
eyelets between the brackets and slide the pin through the
brackets and eyelets (Figure 1).
3. DUST COVER: Slide the dust cover from the top onto the
station as shown in Figure 1.
4. SAFETY SIGN: Mount the safety sign to the wall near the
unit with appropriate hardware provided by installer (see
Figure 2).
OneStep™ Use
1. Pull the bottle forward as shown in Figure 3.
2. Hold eyes open. Hold the bottle 2 to 4 inches above eyes
and pour (Figure 4).
3. Flush the eye thoroughly by rotating the eye back and forth
to rinse the entire area. Repeat flushing as necessary.
4. Proceed immediately to the nearest eyewash station. ANSI
recommends an additional 15-minute water flush treatment
to prevent further infection.
5. Seek medical attention immediately.
6. Discard the bottle, cap and any unused solution.
7. Install a new OneStep™ eyewash bottle in the station
following the instructions outlined in procedure #2 under
"OneStep™ Installation." For replacement bottles: 16-oz.
bottle, 6-pack (S19-924), 32-oz. bottle, 6-pack (S19-925).
2
7/6/04
SLIDE PIN
THROUGH
BRACKETS
AND EYELETS
15-minute
flush
15 minutes
de rinçage
15 minutos
de enjuague
www.bradleycorp.com
Figure 3
Bradley Corporation • 215-1547 Rev. A; EN 04-543
Installation Instructions
Figure 1
DUST
COVER
(107-537)
STATION
Figure 2
1
MOUNT SAFETY
SIGN (114-089)
Rinse
TO THE WALL
Rincer
THROUGH TWO
MOUNTING HOLES
Enjuague
2
Figure 4
Publicité
