Anchor point requirements
ANSI
The anchor point shall be able to sustain a minimum certified load of 3600 lbs
(16 kN) or 5000 lbs (22.2 kN) in the absence of certification. Refer to ANSI Z359.14-
2012 CLASS B.
CSA
The anchor point shall be able to sustain a minimum load of 5000 lbs (22.2 kN).
Refer to CSA Z259.15 CSA Z259.13, CSA Z259.15
Note: If multiple fall arrest systems are attached to the same anchor point the strength
requirement shall be multiplied by the number of personal fall arrest systems.
Lanyard
Always use an energy absorbing lanyard or retractable type fall arrestor that complies with the
relevant standards within the country of use. In some Approved harness variants, side attachment
points are included. These attachments are only to be used for a suitable work positioning lanyard.
ANSI
CSA
Connectors
Connectors shall conform to the relevant national standards and must be compatible.
ANSI
CSA
Pre-use checks
The Latchways PRD has been designed to be easy to use, incorporating a range of features
to aid pre-use checks and on-site periodic examination. This minimises the need to return the
device to Latchways or an authorised agent. No repairs, modifications or alterations are to be
carried out on the Latchways PRD. If any part of the Latchways PRD is found to be faulty, or a
fault is suspected, the device shall be removed from service and advise sought from Latchways
or an authorised agent.
Problem identified
68220-96US-1 PRD Descender user instructions US.indd 7
ANSI Z359.1 or ANSI Z359.13
CSA Z259.2.2, CSA Z259.11
ANSI Z359.1 or Z359.12
CSA Z259.12
Passes checks
EN
7
21/03/2016 11:33