Remote Control - Linea 2000 Domo DO-324A Mode D'emploi

the forming of mold.
- Turn off the unit, remove the plug from the socket and remove the batteries
from the remote control.
Clean the filters and place them back in the unit.
-
- Store the unit in a dry, dark place.
POSSIBLE PROBLEMS AND THEIR SOLUTIONS
The appliance isn't working when pressing the on/off touch.
-
o
o
- The room is not cool enough.
o
o
o
o
- The appliance is making to much noise or is causing vibrations.
o
- Your appliance makes a gurgling sound
o

REMOTE CONTROL

GENERAL
- The remote control will only function within 8 m of the airco. Point the re-
mote in the direction of the airco. The transmission will be confirmed with a
beep signal.
- The airco will not react to the remote if the signal is blocked by curtains,
doors or other materials.
- Make sure the remote doesn't get wet. Don't expose the remote to direct sun-
light or heat.
- When the infrared sensor on the appliance is positioned in direct sunlight it is
possible that it won't react to the remote control. Make sure there is no direct
sunlight on the infrared sensor.
- When other electrical appliances are reacting to the remote control, remove
them further away from the airco or contact your supplier.
- Don't use old and new batteries at the same time in the remote control. Don't
The error code P1 is dispayed , drain the water from the airco.
The room temperature is lower than the selected temperature. Adjust
the selected temperature.
The windows and doors aren't closed. Make sure all windows and
doors are closed.
There are heat sources in the room. Remove all heat sources if pos-
sible.
The air outlet hose is not connected or blocked. Attache the hose and
check if there is no blockage.
The selected temperature is to high. Adjust the selected temperature.
The floor is nog level or flat. Place the appliance on the flat and level
surface if possible.
The sound is produced by the refrigerant in your appliance, this is
normal.
63
DO-324A