CARLO GAVAZZI CA12CA Manuel D'instructions page 20

2.5.2.3. Windows mode procedure
1) Single value teach command sequence:
#65 "SP1 Single value teach"
#66 "SP2 Single value teach"
#64 "Teach apply" (optional command)
2) Dynamic teach command sequence:
#71 "SP1 dynamic teach start"
#72 "SP1 dynamic teach stop"
#73 "SP2 dynamic teach start"
#74 "SP2 dynamic teach stop"
#64 "Teach apply" (optional command)
Command Sequence
1) "SP1 Dynamic Teach Start"
2) "SP2 Dynamic Teach Stop"
3) "Teach Apply"
20
Rev.00 - 01.2024 | CA12CA/EA/KA Capacitve sensors with IO-Link interface | © 2024 | CARLO GAVAZZI Industri
Sensor
Command Sequence
1) "SP1 Single value Teach"
3) "Teach Apply"
2) "SP2 Single value Teach"
3) "Teach Apply"
Sensor
SSC
SSC
Sensing distance
Sensing distance