Publicité
HOW TO REPLACE THE LED LAMP?
1. Take off the baffle fitler. Loose the screws showed on Pic 1 and take out the oil cup.
2. Use the screw driver to push the LED lamp out of the panel through the hole.Please refer to
Pic 2 below.
3. Disconnect the LED terminator and then replace it with new LED lamp. And reconnect the
terminator. Fix the new lamp back to position.
4. Install the oil cup back to position and fix the 2 screws back to position.Install the filters back
to position. Please refer to Pic.4 below.
1.
Oil cup
Filter
TROUBLESHOOTING
Issue
The range hood doesn't turn on
The range hood turns on but the
LED light doesn't
The range hood vibrates when
the blower is on
The blower or fan seems weak
2.
Led lamp
with terminator
• Check if the range hood is plugged in. Make sure that all
power is turned ON, the fuse isn't blown and all electrical
wirings are properly connected.
• Replace the defective LED assembly. Refer to "HOW TO
REPLACE LED LAMP" section.
• Check and tighten the mounting screws to secure the
hood to the cabinet or wall properly.
• Check that the duct size used is at least 6" Range hood
WILL NOT function efficiently with insufficient duct size.
For example: 6" duct over 7" top vent and not sealed
properly.
• Check if the duct is clogged or the damper (half-circular
flapper) is not installed correctly or opening properly. A
tight mesh on a side wall cap might also cause restriction
to the air flow.
3.
Led lamp
with terminator
Possible Cause / Solution
8
4.
Oil cup
Filter
Publicité
