Publicité
Les langues disponibles
Les langues disponibles
English
8.
Turn shutoff valve "H" to "ON" position. Flush water into a
bucket to get rid of particles that may clog the inlet valve.
9.
Turn shut-off valve to "OFF" position
DRAIN HOSE
10.
or floor on the side of the opening closest to the sink.
11.
Connect drain hose to waste tee or waste disposer
following one of the following methods:
a waste disposer
no waste disposer
*An air gap is recommended
11a. WASTE DISPOSER & AIR GAP
1. Remove the disposer knockout plug. Cut end of drain
2. Attach drain hose to air gap "J" with large spring-type
3. Use a rubber hose *connector "L" with spring or screw-type clamps* "M" to
connect air gap to disposer inlet "N". The connection "N" MUST be made
dishwasher will be installed. Go to step 12.
11b. NO WASTE DISPOSER & AIR GAP
section).
2. Attach drain hose to air gap "J" with large spring-
3. Use a rubber hose *connector "L" with spring or screw-type *clamps "M" to
connect air gap to waste tee "P". This connection "P" MUST be made before
will be installed. Go to step 12.
* Parts available from local pumbing supply stores.
13
an air gap
no air gap*
an air gap
no air gap*
11a.
11c.
11b.
11d.
P
Publicité
