Graef HB82 Instructions D'utilisation page 26

sition the screwdriver in the gap between the upper cover and the plastic
housing and lever up the cover.
• Removing the main circuit board
Now the circuit board is exposed on the upper side of the motor unit.
Using a Phillips screwdriver, remove the little screws for fastening the circuit
board and lift the circuit board out of the "speed button". Using a side cutter,
for example, cut through the connection cables one after the other. Using
insulating tape, stick over the individual connections to isolate the contacts.
• Removing the accessories holder
Using a small (rubber) hammer, strike off the plastic cover of the accessories
holder below the release buttons.
• Removing the battery pack and the motor
Cautiously pull out the battery pack and motor.
Despite of complete discharge, the battery pack has a remaining capacity
which can be released in case of a short circuit.
Remove the battery pack and disconnect the connections of the battery pack
individually one by one. Using insulating tape, stick over the individual connec-
tions to isolate the contacts.
Battery packs must not be disposed of in household rubbish. Take it
to the waste collection depot intended for the purpose.
DISPOSAL OF THE UNIT
At the end of its service life, this product cannot be disposed of in
normal domestic waste. The symbol on the product and in the oper-
ating instructions point out to this fact. Reuse the materials according
to their marking. With the reuse, recycling or other forms of recycling
of old equipment, you make an important contribution to the protec-
tion of our environment. Please ask your municipal administration for the dispos-
al point.
WARRANTY
For this product, we assume 24 months manufacturer warranty for defects, which
are due to production or material defects. Your legal warranty claim in con-
formity with Section 439 et seq. of the German Civil Code (BGB) shall remain
unaffected by this regulation. The guarantee does not cover any damage which
26