Publicité
Les langues disponibles
Les langues disponibles
f) Inserting the Drive Battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. d) and e).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH drive battery with 6 or 7 cells (nominal voltage 7.2 V or 8.4 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed control-
ler. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
Check that the rechargeable battery has a plug system matching the speed controller and that the polarity
is right (red cable = plus/+, black cable = minus/-).
Remove the two hook-and-loop tapes (A) of the battery holder.
Then insert the drive battery into the battery holder (B).
If the rechargeable battery has a very short connection
cable, the rechargeable battery must be inserted into
the rechargeable battery holder so that the connection
cable points forwards.
Pull the hook-and-loop tapes (A) tight so that the drive
battery is seated firmly, and close the hook-and-loop
tape.
g) Connecting the Drive Battery to the Speed Controller
To prevent sudden start-up of the wheels
and therefore uncontrolled starting of the
model (e.g. if the trimming for the drive is
maladjusted), place the model vehicle on a
suitable support (or starting box), so that the
wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the
wheels.
Switch off the speed controller first (switch position "OFF"). The on/off switch is at the top of the chassis, right next to
the steering servo. Then switch on the transmitter if you haven't done so yet (see chapter 9. d) and e)).
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable = mi-
nus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH drive battery with 6 or 7 cells (nominal voltage 7.2 V or 8.4 V).
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.
36
Publicité
