Publicité
Les langues disponibles
Les langues disponibles
Touchscreen
ya
MM
M
M
MH
—À—M—
MÀ
MM
MM
HQ
oe MÀ
MÀ
n—
Á——
M
MM
M
—
9
:
v
c Configuring
the Touchscreen;
When needed. the touchscreen can be configured using the following steps.
1 : Windows 2000: T.
9 GB
nU
Select & from the taskbar or select [Settings] from [Start] - [Programs] - [UPDD]
WindowsXP"
Select & from the taskbar or select [Settings] from [Start] - [All Programs] - [UPDD]
The following screen will be displayed.
General
Set the general settings and functions.
Windows
Set the "double-click" settings.
Calibration
Events
Set the events that can be generated by a
controller.
Devices
Configure the device controller.
Define the calibration setup.
Use when the cursor can not be pointed
E
" | correctly with the finger or stylus. (Needed
Hardware
if the alignment of the touchscreen with the
visual image change or adjust the display
resolution).
«Only for CF-M34 series»
Before you run the calibration, you need
to set the device at [Calibration settings
Set the hardware resources.
Match this setting with the set-
ting for [Touch Screen] in the
Setup Utility.
Settings
|
Display the version number.
NOTE i
|
Status
For more information, refer to [Help].
Display the status of the controller.
2 Make necessary changes
3 Select [OK]
«For CF-M34 series only»
6 You can use the touchscreen without changing the settings when the LCD Monitor is connected to Serial Port B. To
connect to Serial Port A, select [Hardware] and set [Settings For] to [Device 2] and [COM port] to [COM 11.
«For the model with the Display Rotation Tool only»
@ Rotate the display to landscape mode (0 degrees) before performing the calibration.
10
Publicité
