Publicité
Les langues disponibles
Les langues disponibles
1. IMPORTANT SAFETY INSTRUCTIONS
This guide provides installation and operation instructions for this pump. If
you have any other questions about this equipment, please consult your
supplier.
1.1 When installing and using this electrical equipment,
basic safety precautions should always be followed,
including the following:
READ AND FOLLOW ALL INSTRUCTIONS.
WARNING – To reduce the risk of injury, do not permit
children to use this product unless they are closely supervised
at all times.
WARNING – Risk of Electric Shock. Connect only to a
branch circuit protected by a ground-fault circuit interrupter
(GFCI). Contact a qualified electrician if you cannot verify
that the circuit is protected by a GFCI.
The unit must be connected only to a supply circuit that is
protected by a ground-fault circuit interrupter (GFCI). Such a
GFCI should be provided by the installer and should be tested
on a routine basis. To test the GFCI, push the test button. The
GFCI should interrupt power. Push the reset button. Power
should be restored. If the GFCI fails to operate in this manner,
the GFCI is defective. If the GFCI interrupts power to the pump
without the test button being pushed, a ground current is
flowing, indicating the possibility of an electric shock. Do not
use this pump. Disconnect the pump and have the problem
corrected by a qualified service representative before using it.
WARNING – To reduce the risk of electric shock, replace
the damaged cord immediately.
CAUTION – This pump is for use with permanently-
installed pools and may also be used with hot tubs and spas if
so marked. Do not use it with storable pools. A permanently
installed pool is constructed in or on the ground or in a
building such that it cannot be readily disassembled for
storage. A storable pool is constructed so that it is capable of
being readily disassembled for storage and reassembled to its
original integrity.
WARNING:
• Fill the pump with water before starting. Do not run the pump dry. In case of dry run, mechanical seal will be
damaged and the pump will start leaking.
• Before servicing the pump, switch power OFF to the pump by disconnecting the main circuit to the pump and
release all pressure from pump and piping system.
• Never tighten or loosen screws while the pump is operating.
• Ensure that the inlet and outlet of the pump are unblocked with foreign matter.
Do not install within an outer enclosure or beneath the skirt of
a hot tub or spa.
A solid copper bonding conductor not smaller than 8 AWG
(1/32") shall be connected from the accessible wire connector
on the motor to all metal parts of the swimming pool, spa, or hot
tub structure and to all electrical equipment, metal conduit, and
metal piping within 5 feet (1.5 m) of the inside walls of a
swimming pool, spa, or hot tub, when the motor is installed
within 5 feet of the inside walls of the swimming pool, spa, or hot
tub.
For Use with Swimming Pools, Hot Tubs, and Spas.
CAUTION: This Pump is for Use with Permanently-Installed Pools
Only – Do Not Use with Storable Pools.
CAUTION: To reduce the risk of electric shock, install at least 6
feet from the inside walls of a pool. Do not use an extension cord.
CAUTION: To ensure continued protection against shock
hazard, use only identical replacement parts when servicing.
This pump is for use with permanently installed in-ground or
above-ground swimming pools and may also be used with hot
tubs and spas with a water temperature under 50℃
. Due to the fixed installation method, this pump is not suggested
to be used on above-ground pools that can be readily
disassembled for storage.
The pump is not submersible.
Never open the inside of the drive motor enclosure.
SAVE THESE INSTRUCTIONS.
3
INVERFLOW
Publicité
