Publicité
Les langues disponibles
Les langues disponibles
DETERGENT AND RINSE AID
dishwasher
and
make
it difficult
to achieve
good
results.
A
water
softener
is recommended
to avoid
damage
and
achieve
good
results.
You may
bring
your
water
samples
to
Sears
to check
hardness
level.
IMPORTANT:
Use only automatic dishwashing
detergent.
Hand dishwashing
detergent
will produce excessive suds and
overflow
out of the dishwasher.
Recommended
Detergent
Amount
Add recommended
amount of detergent to each
compartment
as shown and close the detergent lid.
Powders and Gels
Water
Soil
Pre-Wash
Main Wash
Hardness
Level
Compartment
Compartment
Soft
Light
None
1/2
(0-4 grains
Normal
None
1/2
per U.S.
gallon)
Heavy
Full
1/2
Medium
Light
None
1/2
(5-9 grains
Normal
1/2
1/2
per U.S.
gallon)
Heavy
Full _
Full _
Hard
Light
1/2
Full _
(10-14 grains
Normal
Full _
Full _
per U.S.
gallon)
Heavy
Full _
Full _
_Full pre-wash
compartment
contains 7 tsp (35 mL), and full
main wash cup contains 9 tsp (45 mL).
Premeasured Detergents
Many
detergents
now come in premeasured
forms (gel
packs, tablets, or powder
packs). These forms are suitable for
all hardness and soil levels. Always
place premeasured
detergents
in the main compartment
and close the lid.
Using dishwasher
detergent
tablets
and packs have been
proven better than powder,
liquid or gel detergents
to reduce
filming
on your dishes. By using these tablets
and packs, over
time this will start to reduce or eliminate
white film. Also, by
using a rinse aid you can minimize
repeat buildup
of white
film.
IMPORTANT:
Extremely
hard water
mineral deposits
(15 grains per U.S. gallon or more) can cause damage
to your
IMPORTANT:
Your dishwasher
is designed
to use a liquid
rinse aid. The use of rinse aids greatly
improves
drying by
allowing
water to drain from the dishes after the final rinse.
They also keep water from forming
droplets
that can dry as
spots or streaks.
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions
this will last 1 to 3 months.
1. Turn the knob to the REFILL position and remove.
2.
Pour rinse aid into the opening
until the indicator
points to
FULL. Do not overfill.
3.
Clean up any spilled rinse aid. Spilled
rinse aid can
create excessive suds.
4.
Replace the knob and turn to the LOCI< position.
NOTE: Indicator
reads correct
fill level when door is
completely
opened.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most water conditions,
the factory setting of 2 will give good results. If you have hard
water and notice calcium buildup on your dishware, you may want
to try a higher setting. If you notice foam in your dishwasher, use a
lower setting.
L0ck
Refill
To adjust the setting
1. Turn the knob to the REFILL position and remove.
2. Turn the arrow inside the dispenser to the desired setting.
3.
Replace the knob and turn to the LOCI< position.
11
Publicité
