Bosch BDU480 CX Notice D'utilisation D'origine page 9

soon you start pedaling again and the speed is below
20/28 mph.
The following options are available for switching off
the eBike system:
– Press the on/off button of the on-board computer.
– Switch off the eBike battery using its on/off button
(some bicycle manufacturer-specific solutions pre-
vent access to the battery on/off button; see the bi-
cycle manufacturer operating instructions).
– Remove the on-board computer from its holder.
If the eBike is not moved for approx. ten minutes and
no button is pressed on the on-board computer, the
eBike system switches off automatically in order to
save energy.
eShift (optional)
eShift is the integration of electronic gear-shifting
systems into the eBike system. The eShift compo-
nents are electrically connected to the drive unit by
the manufacturer. The separate operating instruc-
tions describe how to operate the electronic gear-
shifting systems.
Setting the assistance level
You can set the level at which the eBike drive assists
you while pedaling on the on-board computer. The as-
sistance level can be changed at any time, even while
cycling.
Assistance level
ECO
TOUR
SPORT/eMTB
TURBO
A)
The assistance factor may vary in some models.
B)
Maximum value
Bosch eBike Systems
Performance Line
(BDU490P)
60 %
140 %
240 %
340 %
Note: In some models, the assistance level may be
preset and cannot be changed. There may also be
fewer assistance levels available than stated here.
The following assistance levels are available as a max-
imum:
– OFF: Motor assistance is switched off. The eBike
can just be moved by pedaling, as with a normal bi-
cycle. The push assistance cannot be activated at
this assistance level.
– ECO: Effective assistance with maximum efficiency,
for maximum range
– TOUR: Steady assistance, long range for touring
– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking
and for cycling in urban traffic
eMTB: Optimum assistance whatever the terrain,
rapid acceleration when starting from a standstill,
improved dynamics, top performance (eMTB is
only available in combination with drive units
BDU250P CX, BDU365, BDU450 CX and BDU480
CX. This also requires a software update.)
– TURBO: Maximum assistance even at high pedaling
speeds, for biking sports
The requested motor output appears on the display
of the on-board computer. The maximum motor out-
put depends on which assistance level is selected.
A)
Assistance factor
Performance Line CX
(BDU480 CX)
60 %
140 %
B)
240/140 to 340 %
340 %
English – ​ 7
Cargo Line
60 %
140 %
240 %
400 %
0 275 U07 XD4 | (13.02.2019)