Cisco Systems Linksys WAG200G Guide D'installation Rapide page 3

Repeat this process for every
PC that you want to connect to
the Gateway.
If you are connecting more
than four PCs to the Gateway,
you will also need to connect
a hub or switch to the
Gateway.
NOTE: If your PC's Ethernet
adapter is not set up,
refer to the Ethernet
adapter's user guide for
more information.
D
Connect the power adapter to
the Gateway. Connect the
power adapter to the electrical
outlet. (Figure D)
E
Turn on the Gateway. Then,
turn on the first PC that you
want to use to configure the
Gateway.
IMPORTANT:
place the microfilter or splitter
between the phone and the wall
jack and not between the Gateway
and the wall jack. Otherwise your
ADSL will not connect.
Proceed to Step 2: Configure the
ADSL Home Gateway.
Make sure you only
D
3