cecotec 3D ForceAnodized 750 Smart Manuel D'instructions page 18

ENGLISH
6. TROUBLESHOOTING
Problem
Not enough or too much
heat.
No steam or leakage.
Steam burst or vertical
steam do not work properly.
Water leaks from the
soleplate.
Little steam.
Spray does not work
properly.
7. TECHNICAL SPECIFICATIONS
Model: 3D ForceAnodized 750 Smart
Reference No: 05103
3100 W, 230 V, 50 Hz
Made in China | Designed in Spain
18 3D FORCEANODIZED 750 SMART
05103_3D ForceAnodized 750 Smart_Manual_DS.indd 18
Possible cause
The temperature knob is
not set correctly or it is
unplugged.
The temperature knob has
been set to MIN.
The steam-burst function
has been used too often
within a very short period.
The iron is not hot enough.
The steam and thermostat
knob is set at "0".
The iron is not hot enough.
Water is over the max mark.
Check if the steam knob is in
the correct position.
Steam holes are blocked.
Too little water in the water
tank.
Not enough pressure or air
inside.
Solution
Set the temperature knob
to the correct position.
Continue ironing in
horizontal position and
wait a few minutes before
using the vertical steam-
burst function again.
Set the temperature and
steam knob correctly.
Press the steam button
only after the indicator light
turns off.
Empty the left-over water.
Set the steam knob to the
proper position.
Clean the hole with distilled
water.
Add water to the water
tank.
Press the spray nozzle
manually and press the
spray button several times
in a row.
19/12/18 14:01