Bosch GKF 600 Professional Notice Originale page 15

explosion. Penetrating a water line causes property dam-
age or may cause an electric shock.
Do not use blunt or damaged routers. Blunt or damaged
u
routers cause increased friction, create imbalances and
may become jammed.
Always wait until the power tool has come to a com-
u
plete stop before placing it down. The application tool
can jam and cause you to lose control of the power tool.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for copy routing as well as routing
grooves, edges, profiles and elongated holes in wood,
plastic and light building materials while resting firmly on the
workpiece.
Product features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Drive unit
Technical data
Edge router
Article number
Rated power input
No-load speed
Compatible collets
Weight according to EPTA‑Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Bosch Power Tools
(2) Routing base
(3) Thumbwheel for fine adjustment of routing depth
a)
(4) Router bit
(5) Cap nut with collet
(6) Guide plate
(7) Base plate
(8) Scale for setting routing depth
(9) Spindle lock button
(10) Clamping lever
(11) On/off switch
(12) Handle (insulated gripping surface)
(13) Collet
(14) Tool holder
(15) Open-ended spanner (17 mm)
(16) Knurled screw for attachment of side stop
(17) Parallel guide
(18) Wing bolt for parallel guide
(19) Roller guide
(20) Wing bolt for locking of the horizontal alignment
(21) Wing bolt for horizontal alignment of the roller guide
(22) Guide roller
a)
(23) Base cover sleeve
a)
(24) Tilt base
(25) Wing bolt for angle adjustment
(26) Scale for routing angle adjustment
a)
(27) Handle for the guide plate
a)
(28) Extraction guard
a)
(29) Extraction adapter
(30) Guide plate with handle and extraction adapter
(31) Nut for adjustment of the tensioning force
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GKF 600
3 601 F0A 1..
W 600
−1
min 33000
mm 6 | 8
inches
kg
English | 15
a)
GKF 600
3 601 F0A 16.
3 601 F0A 17.
600
33000
–
– ¼
1.5 1.5
/II /II
1 609 92A 7XZ | (18.07.2022)