Télécharger Imprimer la page

Racing RAC750ET-2 Instructions Originales page 26

Publicité

Les langues disponibles

Les langues disponibles

Starting
Connection the mains (Fig. 2)
Connect the appliance connection line to the safety control combination and secure
it with the cable relief (48). The power cord loop should be long enough for the cord
pass to slide from side to side.
Starting up (Fig. 3)
Press the safety lock button (A) on the switch / socket combination, then pull the
handle (B) against the bar. The engine starts and the teeth begin to spin.
Press and hold the ignition lever while releasing the safety lock button.
To switch off the device, release the joystick which automatically returns to its
starting position.
Use the tiller for breaking sod, preparing seedbeds, and for cultivating gardens and
flower beds. The tiller can also dig small holes for planting saplings or potted plants.
Tips
Move the application to the work area prior to starting the motor.
Hold the application firmly while switch on.
The tines will pull the tiller forward during operation, press the guide bar to lower
the tines slowly.
By pulling tiller back towards yourself, the tines will dig deeper and more
aggressively.
For breaking sod or deep tilling, allow the tines to pull the tiller forward to the end
of your arm's reach, then firmly pull the tiller back towards you. By repeatedly
allowing the tiller to move forward and then pulling back to you, the tiller will be
most effective.
If the tiller digs deep enough to stay in one spot, gently rock the tiller side to side
to start the tiller moving forward again.
For preparing seed bed, we recommend using one of the tilling patterns shown in
Fig. 4.
Tilling Pattern A – Make two passes over area to be tilled, the second at a right
angle to the first.
Tilling Pattern B – Make two passes over area to be tilled, the second overlapping
the first.
To prevent tripping take particular care when moving backwards and when pulling
the tiller.
25

Publicité

loading