Panasonic S-36PF1E5B Mode D'emploi page 7

Maintenance
WARNING
For safety, be sure to turn the air conditioner off and disconnect
z
the power before cleaning. (Otherwise, electric shock or injury may
result because the fan is rotating at high speed.)
Do not pour water on the indoor unit. (This may damage the internal
z
components and cause an electric shock hazard.)
Never use solvents or harsh chemicals. Also, do not wipe plastic
z
parts using very hot water. (This may cause deformation or change
in colour.)
Some metal edges and fins are sharp. Be careful when you clean
z
those parts. (Injury may result.)
Use a firm stool or ladder when cleaning an indoor unit installed in
z
high locations.
„ Air Filter Maintenance
Consult your dealer or service center when the
Timer Remote Controller
Filter indicator
A
„ Heating performance
Since this air conditioner utilizes outside air for heating,
z
its heating performance deteriorates as outside tempera-
ture decreases.
(Due to heat pump system)
→In that case, use another heating appliance.
„ Defrosting
This appliance may start defrosting operation to melt
z
frost formed in the outdoor unit.
D efrosting starts
: The indoor unit fan stops (or the

speed becomes extremely slow).
→" " (STANDBY) appears.
H eating operation resumes after several

minutes
: The indoor unit fan remains stopped (or
it will run at a very slow speed) until the indoor heat
exchanger coil warms up sufficiently.
→ " " (STANDBY) is shown.
 Defrosting is complete
operation.
→ " " (STANDBY) disappears.
CAUTION
(Filter) appears on the display of the wired remote controller.
High-spec Wired
Remote Controller
Filter indicator
20:30 (THU)
Operation Mechanism
: The indoor unit fan starts
Indoor unit
(e.g. Type T2)
Wipe with a soft cloth.
(If it is very dirty, use a cloth moistened with water.)
The internal coil and other components of the
z
outdoor unit must be cleaned periodically.
• Consult your dealer or service center.
„ ''DRY'' operation
Once the room temperature reaches the level that was
z
set, the outdoor unit repeats the cycle of turning on and
off automatically.
When the outdoor unit is turned off, the indoor unit fan
z
will stop, too.
(To prevent the humidity in the room from rising again)
When the room temperature is more likely to reach the
z
level that was set, the fan speed is set to ''breeze'' (light
wind) automatically.
„ Should the power failure occurs while the
unit is running
When the unit automatically resumes operation after
temporary power failure, it uses the same settings before
the power was cut off.
Air outlet
Air intake
E
NGLISH
7