Télécharger Imprimer la page

DoorBird A1121 Serie Manuel D'installation page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4.1 DISASSEMBLING THE FRONT PANEL
(APPLIES ONLY TO THE SURFACE-MOUNTED AND FLUSH-MOUNTED MODEL)
Remove the front panel with the attached Main Electrical Unit carefully from the mounting housing (backbox)
using the orange (Torx+Pin) screw driver provided.
We have designed the front panel and the safety screw in a way that it cannot be screwed through the
front panel so that is does not fall off / get lost during installation..
Flush-mounted model
Turn the safety screw counter-clockwise until it is loose. Pull the front panel with attached Main
Electrical Unit out of the mounting housing (backbox).
4.2 MOUNTING
Lead all cables and wires you want to connect to the device through the mounting housing (for retrofit version:
through the hole in the existing panel).
Flush-mounted model
Please make sure that the outer frame of the flush-
mounted housing rests on the outside of the wall
and that the edge of the flush-mounted housing
is sealed all around against moisture from the
outside.
Surface-mounted model
Surface-mounted model
Before mounting: Pierce through the middle
of the rubber seal for the cable entry using a
screwdriver.
Retro Fit model
9

Publicité

loading