Porter Cable PCG2200 Manuel D'instructions page 30

cODE pOSSIBLE cAUSE
11 Insufficient ventilation
12 Faulty windings in stator
13 Faulty wire harness
14 Low or no fuel
15 Bad fuel
16 Low oil
17 Faulty spark plug
18 Spark plug cap loose
19 No or low compression
20 No spark
21 Spark plug fouling is
sooty or sticky black
22 Dirty air filter
23 Improper valve clearances
24 Governor linkage stuck or bent
25 Throttle shaft stuck
26 Governor spring bent or lost
27 Dirty carburetor
All manuals and user guides at all-guides.com
pOSSIBLE SOLUTION
Move to adequate supply of fresh air
Contact a Customer Care Center.
Contact a Customer Care Center.
Add fuel
Drain fuel tank and replace with fresh,
clean, regular unleaded gasoline
with a minimum of 86 octane
Add oil
Replace spark plug
Attach spark plug cap securely
Tighten spark plug. If problem is not
corrected, contact a PORTER-CABLE
factory service center or a PORTER-
CABLE authorized service center.
Check spark plug cap. If problem
is not corrected, contact a
Customer Care Center.
a. Clean spark plug. See Spark
plug under Maintenance.
b. Check spark plug gap, adjust
if needed. See Spark plug
under Maintenance.
c. Replace spark plug. See
Specifications.
d. If engine still fails to start, con-
tact a Customer Care Center.
Clean or replace the air filter elements
Reset valve clearances. Contact
a Customer Care Center.
Contact a Customer Care Center.
Contact a Customer Care Center.
Contact a Customer Care Center.
Contact a Customer Care Center.
30- ENG