ters are fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45
North, Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include
all of the information shown on the nameplate of your tool (model number, type,
serial number, etc.).
Since accessories, other than those offered by PORTER-CABLE,
have not been tested with this product, use of such accessories with this tool could
be hazardous. To reduce the risk of injury, only PORTER-CABLE recommended
accessories should be used with this product.
A complete line of accessories is available from your PORTER-CABLE Factory
Service Center or a PORTER-CABLE Authorized Warranty Service Center. Please
visit our Web Site www.deltaportercable.com for a catalog or for the name of your
nearest supplier.
TrOUBLESHOOTING GUIDE
This section provides a list of the more frequently encountered malfunctions,
their causes and corrective actions. The operator or maintenance personnel can
perform some corrective actions, and others may require the assistance of a
qualified PORTER-CABLE technician or your dealer.
problem
Engine will not start ........................... 1, 2, 3, 4, 14, 15, 16, 17, 18, 19, 20, 21, 27
No electrical output ............................................................... 5, 6, 7, 8, 9, 10, 12, 13
NOTE: If there is still no power at the receptacles, Contact a Customer Care
Center.
Repeated main breaker tripping ......................................................................... 9, 10
Generator overheating ........................................................................................ 9, 11
Engine does not continue to run after starting ..1, 2, 3, 14, 16, 18, 19, 20, 21, 27
Knocking noise ....................................................................................................23
Over speed or low speed ....................................................................... 24, 25, 26
Low power ........................................................................................ 16, 19, 22, 23
cODE pOSSIBLE cAUSE
1
Engine On/Off switch in OFF
position.
2
Choke in wrong position
3
Fuel shut-off valve in closed
position
4
Unit loaded during start-up
5
Faulty receptacle
6
Receptacle thermal circuit
breaker tripped
7
Defective capacitor
8
Faulty power cord
9
Generator overloaded
10
Faulty cords or equipment
All manuals and user guides at all-guides.com
AccESSOrIES
pOSSIBLE SOLUTION
Turn to ON position
Adjust choke accordingly
Open fuel shut-off valve
Remove load from unit
Contact a Customer Care Center.
Depress and reset
Contact a Customer Care Center.
Repair or replace cord
Reduce load
Check for damaged, bare or frayed
wires on equipment. Replace.
29 - ENG
code