Publicité
Les langues disponibles
Les langues disponibles
1.
3
Place a bracket
upper limit, aligning the center (notch) with the vertical reference line
and mark the wall at the centers of the holes in the bracket.
2.
Place the second bracket
bracket, at the height of the upper chimney section
aligning the center (notch) with the vertical line.
3.
Mark the wall at the centers of the holes in the bracket and mark the
point 1 and 2 for the Hood Body installation as shown(12 5/8" from the
horizontal line and 4 9/16" from the vertical line).
4.
Drill ø 5/16" holes at all the center points marked (point 1,2,3,4,5,6) as
shown.
on the wall as shown about 1/8" from the ceiling or
D
on the wall as shown, below the first
D
C
supplied and
C
D
X
13
Publicité
