Braun 7 Serie Mode D'emploi page 12

high high
low low
1 1
emp ty emp ty
2 2
high high
low low
empt y empt y
high high high high
low low low low
empty empty empty empty
empty empty
auto select auto select
12
e
r
t
z
u
i
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below:
Installing the Clean&Renew station
• Using the special cord set
station power socket
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
new new
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
high high
low low
empt y empt y
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
high high
«high»
low low
«low»
empty empty
«empty» new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts
shaver will align with the contacts
cleaning station).
If required, the Clean&Renew station will now
charge the shaver. The hygiene status of the
high high
low low
shaver will also be analyzed and one of the
following cleaning program diodes
up:
«clean»
clean clean
«eco»
eco eco
«normal»
normal normal
«intensive» high intensive cleaning required
intensive intensive
Reset button
Shaver display
Shaver-to-station contacts
Shaver power socket
Travel case
Special cord set
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
shaver is clean
short economical cleaning required
normal level of cleaning required
i
, connect the
6
to an electrical outlet.
2
to open the housing.
7
down on a fl at,
1
will show how much
t
on the back of the
3
in the
5
will light
i