Hoover H-WASH 500 HWPD 610AMBC/1-S Mode D'emploi page 71

WARNING:
don't touch the buttons while inserting
the plug because
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn't work property. In
this case, remove the plug and repeat
the operation.
PROGRAMME selector with OFF
position
When the programme selector is turned

the display lights up to show the settings
for the programme selected.
Switch off the washing machine by

turning the selector to OFF.
First starting
- Language setting
After connecting the machine to the

network and turning it on, press the "B" or
"C" button to display the available languages.
Select the desired language pressing the

START/PAUSE button.
- Change the language
If you want to change the setting language
you will have to press simultaneously "D"
and "F" buttons for about 5 seconds.
ENGLISH will appear on the display, and
you will be able to choose a new language.
- Water Hardness setting
This washing machine, thanks to the CARE
DOSE system, is able to dose your
detergent automatically.
quantity of detergent depending on the
water hardness, on the load quantity and on
the chosen cycle (cotton, delicates,etc...)
The default setting for the water
hardness is set in the factory at level 2
(L2) as this satisfies the requirements
of the majority of users.
the machines
The optimum
71
Water Hardness level:
L1 = LOW (0-12 °fH o 0-7 °dH)
L2 = MEDIUM (13-30 °fH o 8-17 °dH)
L3 = HIGH (≥ 30 °fH o ≥ 17 °dH)
To confirm the standard water hardness

level set by the factory, press START/
PAUSE button.
If you want to change the standard water

hardness setting (and consequently the
amount of detergent dispensed), press
CARE DOSE button.
Once chosen the water hardness level,

confirm by pressing the START/PAUSE
button.
- Change the water hardness setting
If you want to change the water hardness

setting (and consequently the amount of
detergent dispensed), hold down the
CARE DOSE button for a few seconds.
The wording WATER HARDNESS will
appear on the display and you can
choose the desired level by pressing the
CARE DOSE button again. The higher
the water hardness,
detergent will be dispensed.
Confirm by pressing the START/PAUSE

button.
Check the water hardness LEVEL of
your city at
company before using the CARE
DOSE function.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
To start the selected cycle with the preset

parameters, press START/PAUSE. When
the programme is running, the display will
show the time to elapse.
the more
your water supply