Domo DO156A Mode D'emploi page 18

CONTROL PANEL
1. Timer
2. COOL: humidifier/ cooler
3. WIND: oscillation
4. Speed settings LO – MI – HI (low – middle – high)
5. STOP: button to turn off the speed settings
USE
1. Fill the water tank with clean water. Make sure that the water does not exceed the maximum
indication (check the water level indication at the front of the air cooler). Also make sure that the
drain plug is secured in the drain hole at the bottom of the water tank.
2. Fill the 2 ice packs with water and put them in the freezer until they are completely frozen.
3. Place 1 ice pack in the water tank and close the water tank. The temperature of the water will
approximately be reduced until 6°C below room temperature and this will remain so for 4 hours, so
that the wind is cooled.
4. Add the second ice pack for an even lower temperature. The 2 ice packs are reusable.
Warning: Always fill the water tank with water before using the COOL function. Never use the COOL
function without water in the water tank.
FUNCTIONS
STOP-LO-MI-HI
Press the LO button for a low wind speed, the MI button for a medium speed and the HI button for high
speed. Press the STOP button to stop the air flow.
TIMER
· Set the timer knob to I to switch on the air cooler (stand-by).
· Set the timer knob to 0 to switch off the air cooler.
· Turn the timer knob from 0 to 120 to set the timer, with a maximum of 2 hours (120 minutes).
WIND
By pressing the WIND button, the vertical air vent will move from left to right to spread the air flow. Push
again this button to deactivate the function.
COOL
Make sure that there is clean water (and ice packs if preferred) in the water tank before using the cool
function. When you press the COOL button, the water pump will pump water to the honeycomb filter to
obtain a cool air flow. Push again this button to deactivate the function.
18
DO156A
5
4
3
2
1