Télécharger Imprimer la page

Domo DO9253IB Mode D'emploi page 25

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
DESCALING
Descale the appliance regularly to avoid calcification and to maintain a well operating appliance. Use a
descaling product for for example coffee makers, or use a solution of 1/2 vinegar and 1/2 water.
Fill the water tank with the product/solution (do not exceed the maximum level) and switch on the
appliance. The appliance will now pump water into the ice tray. Wait until the tray is filled with water (the
supply of water to the tray will stop) and immediately press the ON/OFF button. The appliance switches
off and will release the product/solution from the ice tray. Repeat this cycle a few times with the descaling
product/solution. Afterwards, fill the water tank with clean water and repeat the procedure until the smell
of the descaling product/solution has disappeared completely.
POSSIBLE PROBLEMS AND THEIR SOLUTIONS
PROBLEM
The compressor makes a lot of noise.
Indicator lamp 'water reservoir empty'
(ADD WATER) lights up.
There are no indicator lights on.
The ice is too big and there are bits of
broken ice sticking to it.
The appliance goes through the cycle, but
no ice comes out.
All indicator lights flash simultaneously.
The appliance works, but the water gets
warm.
www.domo-elektro.be
POSSIBLE SOLUTION
·
Check that the voltage indicated on the appliance
corresponds to the voltage of the electricity grid in
your home.
·
Is the water reservoir empty? Fill the water reservoir
with water.
·
There's air in the pump. Restart the appliance with
the on/off button.
·
There is no power applied to the appliance. Check
the plug is placed in the socket.
·
Make sure the fuse is not broken.
·
It is possible that ice from a previous cycle has ended
up in the water reservoir. Turn off the appliance and
remove the ice from the water reservoir.
·
Make sure the water in the reservoir is not too warm
or cold. The recommended water temperature is
between 8°C and 25°C.
·
The compressor or the ventilation motor is broken.
Contact the after-sales service.
·
There is insufficient coolant in the appliance. Contact
the after-sales service.
·
The ambient temperature is too warm. The device
will not work as desired with temperatures higher
than 32°C.
·
The water reservoir is blocked by ice cubes. Pull the
plug out of the socket, remove the ice from the water
reservoir. Plug the power cord back in and press
the on/off button. The appliance will restart after 3
minutes.
·
Contact the after-sales service.
25
DO9253IB

Publicité

loading