Publicité
INSTALLATION
mobile home/transportable building. This type of
installation is also required in air tight houses and
houses with negative pressure problems. You can
purchase this option through your heater dealer.
Make sure to specify the part number mentioned
in this booklet. Installation instructions are supplied
with the air intake kit. Outside combustion air may
be required if:
1.
Your stove does not draw steadily, smoke roll-out
occurs, wood burns poorly, or back-drafts occur
whether or not there is combustion present.
2. Existing fuel-fired equipment in the house, such
as fireplaces or other heating appliances, smell,
do not operate properly, suffer smoke roll-out
when opened, or back-drafts occur whether or
not there is combustion present.
3. Opening a window slightly on a calm (windless)
day alleviates any of the above symptoms.
4. The house is equipped with a well-sealed vapor
barrier and tight fitting windows and/or has any
powered devices that exhaust house air.
5. There is excessive condensation on windows in
the winter.
6. A ventilation system is installed in the house.
Slide the hose clamp over the aluminium flex pipe.
Then slide the flex pipe over the air intake tube of
the stove. Next tighten the hose clamp over the end
of the aluminium flex hose.
FOR USE IN MOBILE HOME/TRANSPORTABLE
• WARNING! DO NOT INSTALL IN SLEEPING
ROOM.
• CAUTION! THE STRUCTURAL INTEGRITY
OF THE MOBILE HOME/TRANSPORTABLE
BUILDING FLOOR, WALL, AND CEILING/
ROOF MUST BE MAINTAINED.
• INSTALL IN ACCORDANCE WITH 24 CFR,
PART 3280 (HUD).
• USE A FACTORY BUILT CHIMNEY THAT
COMPLIES
WITH
THEREFORE IT MUST BE A TYPE HT (2100°F).
• USE A SPARK ARRESTER.
• THE STOVE MUST BE ATTACHED TO THE
STRUCTURE
TRANSPORTABLE BUILDING.
SECURING APPLIANCE'S ON A
PEDESTAL TO THE FLOOR
Use the designated holes to secure the unit to the
floor.
SECURING APPLIANCE'S WITH LEGS TO
THE FLOOR
1.
The bracket engages around the square
extrusion of the leveling bolt inserted into the
leg.
2. Once appliance is leveled, position the bracket
and attach to the floor using the appropriate
hardware needed for your specific flooring.
3. Install one bracket per leg or consult your local
authority having jurisdiction to determine how
many points of attachment are required.
7
© 2024 United States Stove Company
BUILDINGS
UL
103
STANDARDS;
OF
THE
MOBILE
HOME/
Publicité
