Publicité
OPTIONAL CB36 BLOWER WIRING DIAGRAM
DANGER: SHOCK HAZARD DISCONNECT POWER SOURCE
BEFORE INSTALLATION AND WHENEVER SERVICING
BLOWER ASSEMBLY.
WHITE /
BLOWER
RHEOSTAT /
RHÉOSTAT DU
VENTILATEUR
NOTICE: ANY REPLACEMENT WIRING MUST HAVE EQUIVALENT INSULATION AND TEMPERATURE
NOTICE: DO NOT ALLOW THE POWER CORD TO TOUCH HOT SURFACES! KEEP THE POWER CORD
AT LEAST 12"/30.5CM FROM THE STOVE OR PIPE SURFACES.
INSTRUCTIONS SPECIFIC FOR CANADIAN
Do not obstruct the space under the heater and do
not obstruct the combustion air openings.
Refer to the chimney manufacturer's instructions
for disassembling the chimney for transportation
of a transportable building.
The parts or materials to be employed for ember
protectors and the minimum areas to be covered
and their relation to the space heater, as well as
the notice: "In Canada, to comply with CSA B365,
Installation Code for Solid-Fuel-Burning Appliances
and Equipment, any combustible covering beneath
the appliance and/or within the area extending
horizontally at least 450 mm (18in) beyond the
appliance on any side equipped with a door, and at
least 200 mm (8in) beyond the appliance on other
sides, shall be protected by a continuous, durable,
non-combustible pad that will provide ember
protection. The 450 mm (18in) ember protection
© 2024 United States Stove Company
BLACK /
BLANC
NOIR
BLACK /
BLACK /
NOIR
NOIR
GREEN /
VERT
RATING (105° C).
INSTALLATIONS
CAUTION: MOVING PARTS CAN
CAUSE INJURY. DO NOT OPERATE
BLACK /
NOIR
BLACK /
NOIR
BLOWER SPECS: 120VAC, 60 Hz AC,0.55amp
MOTEUR DE VENTILATEUR
SPÉCIFICATIONS DU VENTILATEUR : 120 V CA,
WHITE /
BLANC
required on any side with a door shall extend for the
full width of the appliance plus the 200 mm (8in)
required on each side of the appliance without a
door. Where an appliance is installed less than 200
mm (8in) from a wall, the ember pad need only
extend to the base of the wall. An ember pad shall
not be placed on top of a carpet unless the pad is
structurally supported to prevent displacement
and distortion.
Note: Do not install the chimney directly at the
outlet of the appliance. A chimney connector (flue
pipe) is required.
If this appliance is installed in a transportable
building, removal of the chimney is required for
transportation of the building.
DO NOT INSTALL IN AN ALCOVE
DO NOT INSTALL IN ANY FIREPLACE
18
WITH COVER REMOVED.
BLOWER MOTOR
60 hz CA, 0,55 AMP
/
Publicité
