Publicité
Les langues disponibles
Les langues disponibles
It may be difficult to see the indicator,
make sure it is properly lit.Each time the
temperature setting device is changed,
wait for the stabilisation of the temperature
inside the appliance before proceeding,
if necessary, with a new temperature
setting. Please change the position of the
temperature setting device progressively
and wait at least 12 hours before starting a
new check and potential change.
NOTE: Following repeated openings
(or prolonged opening) of the door or
after putting fresh food into the appliance, it
is normal for the indication "OK" not to
appear in the temperature setting indicator.
If there is an abnormal build up of ice
crystals of ice crystals (bottom wall of the
appliance) on the refrigerator compartment,
evaporator (overloaded appliance, high
room temperature, frequent door openings),
put the temperature setting device on a
lower position until compressor off periods
are obtained again.
Store food in the coldest area of the
refrigerator.
Your foods will be better stored
if you put them in the most
appropriate cooling area. The
coldest area is just above the
crisper.
The following symbol indicates the coldest
area of your refrigerator.
To be sure to have a low temperature in this
area, make sure the
shelf is located at
the level of this
symbol, as shown in
the illustration.
The upper limit of
the coldest area
is indicated by the
lower side of the
sticker (head of the arrow). The coldest
area upper shelf must be at the same level
with the arrow head. The coldest area is
below this level.
As these shelves are removable, make
sure they are always at the same level with
these zone limits described on the stickers,
in order to guarantee temperatures in this
area.
The Turbo Fan (if available)
Do not block the air inlet and outlet
openings when storing food, otherwise air
circulation provided by the turbo fan will be
impaired.
3.4 Accessories
3.4.1 Ice Tray
• Fill the ice tray with water and place in
the freezer compartment.
• After the water has completely frozen,
you can twist the tray as shown below to
remove the ice cubes.
3.4.2 The Plastic Scraper
After some time, frost will build up in certain
areas of the freezer. The frost
accumulated in the freezer
should be removed regularly.
Use the plastic scraper
provided, if necessary. Do not
use sharp metal objects for this
operation. They could puncture the
refrigerator circuit and cause irreparable
damage to the unit.
Visual and text descriptions in
the accessories section may vary
according to the model of your
EN - 30
Turbo fan
appliance.
Publicité
