Publicité
Les langues disponibles
Les langues disponibles
Operation
5.4
Adjustment of the height adjustable support (accessory)
When using the device in batch operation, for gripping of single stone slabs (batched one upon the
other), we advise to use the accessory "height adjustable support" HVA-FTZ/TSZ (see figure).
Therefore, the inside height must not always be adjusted again for gripping goods with the same
dimensions.
When picking up in batch operation the top stone slab
may only be lifted!
•
The height adjustable support (B) is attached to the
mounting plate (A)
•
Adjust the height adjustable support (B) with the
adjusting screws and make sure that both parts have
the same height and that the rubber gripper bars are
positioned in the middle area of stone thickness.
6
Operation
6.1
Operating for devices with automatic release
•
The device is connected to the lifting equipment/carrier (e.g. excavator).
•
Before lifting the device, the gripping range has to be adjusted.
•
The device is placed over the product, set down, the device closes round the product and it can be
lifted.
•
Set down on the ground again, the device opens automatically, the automatic release locks it into
position so that the device can be lifted without closing up.
•
Placed over the next product, the automatic release disengages itself and the product can be lifted.
The device therefore is a ONE-MAN-MACHINE.
Shut-down the device without lifting equipment/carrier only on even ground. The gripping arms
must be opened enough, to ensure a secure standing of the device. Otherwise there is a danger
of overturning!
53100313
15 / 20
Fig. 1
GB
Publicité
