Publicité
Les langues disponibles
Les langues disponibles
Adjustments
5
Adjustments
5.1
Adjustment of the gripping range
Before gripping material can be lifted and moved, the corresponding gripping range must be set.
Otherwise it cannot be guaranteed that the clamping force is sufficient for safe gripping of the material to be
lifted and the material could slip off!
•
When adjusting the grab range, the unit must stand securely on the ground.
•
Never adjust the gripping range on both sides simultaneously.
Always adjust the gripping range first on one side and then on the other.
•
Lift the unit approx. 0.5 m. Gripping arms must be locked and open (automatic changing device in
position "empty").
•
Unlock bolt with half ring (1) by pulling out the hinged pin (2).
•
Pull out bolts with half ring (1) each time the gripping range is adjusted and move rectangular tubes
against each other until the opening width at the rubber jaws is approx. 5 cm larger than the gripped
material itself.
•
Re-insert the bolt with the half ring (1) and secure with the cotter pin (2).
•
Gripping range adjustment must generally be symmetrical (via both rectangular tubes with
adjustment holes).
•
Be careful when adjusting the gripping range. Risk of injury to the hands!
→ Use protective gloves.
•
Defective safety elements (folding pins) must be replaced without fail!
53100313
Gripping range
adjustment
1
13 / 20
2
GB
Publicité
