Publicité
Les langues disponibles
Les langues disponibles
amount of careful design by us, and care-
ful maintenance by you, can guarantee a
repair-free life for your Fusion® cultivator.
Most repairs will be minor and easily fixed
by following the suggestions in the trou-
ble-shooting guide in this section.
The guide will help you pinpoint the
causes of common problems and identify
remedies.
For more complicated repairs, you may
want to rely on an authorized service
center. A parts breakdown is located in
this manual.
We will always be glad to answer any
questions you have, or help you find suit-
able assistance. To order parts or inquire
about warranty, call or email us using the
TROUBLE
Drill does not start
Tines spin but
performance is not
desirable
Drill stops or clutch slips
when cultivating
Cultivator operates for a
few minutes, then slows
to a stop
Get parts online at www.fusiondrillpowered.com or call 800-345-6007 M-F 8:00am-4:30pm CST.
CAUSE
Drill is not properly
connected to unit
Extension is not
connected properly to
the transmission
Defective or broken drill
Defective or dead
battery
Drill speed setting is
too fast
Broken transmission
Debris or object is stuck
in the tines
Drill clutch torque
setting is too low
Drill battery charge is
low
Capacity of the drill's
battery is insufficient
Model Number:
contact information found below or listed
on the 'Contact Us' page on our website.
For any problems and/or repair with your
drill, please consult your drill's manu-
facturer. Ardisam is not responsible for
damage to the drill due to misuse of the
cultivator.
ORDERING REPLACEMENT PARTS
Parts can be obtained direct from
the factory. To order parts, visit
www.fusiondrillpowered.com or call
(800) 345-6007. Please include the follow-
ing information with your order:
Part Number(s), Part Description(s), Quan-
tity, Model Number and Serial Number.
CORRECTION
Check connection and secure according to
assembly instructions
Check connection and secure according to
assembly instructions
Contact drill manufacturer or replace drill
Replace or charge battery on drill
Decrease drill speed setting to slower speed
Inspect and replace damaged parts
Remove debris or object from tines
Increase clutch torque setting until
cultivator is operable in soil
Check battery charge level and replace or
charge if necessary
Replace battery with one that has a
capacity of 3.0 Ah or greater
Drill-Powered Cultivator
33061
15
Publicité
