Fusion 33061 Manuel De L'utilisateur page 10

ASSEMBLY
1. Remove contents from packaging and
open hardware parts bag.
2. Assemble tine shield bracket (K) to
transmission (J) with four bolts (A) and
four nuts (B) using L-wrench (G), provided
in hardware parts bag. SEE FIGURE 2
3. Assemble tine shield (L) to trans-
mission assembly with bolt (C) using
L-wrench (G). SEE FIGURE 2
4. Assemble four tines (M) to transmis-
sion assembly with four hair pins (N).
SEE FIGURE 3
5. Assemble handle (O), along with right
torque arm assembly (Q) and left torque
arm assembly (R) to extension (P) with
two bolts (E) and two hand knob nuts
(D). Though the handle can be installed
in either direction on the extension, it is
most common to have the Fusion® logo
facing toward the op-
erator and drill. Be sure
the locator stud on the
aluminum tube of the
extension fits snuggly
all the way into one
of the five pocket
positions of the handle
depending on the
user's desired angle
position of the handle.
Then tighten the hand
knob nut firmly by
hand on the bolt to
secure the handle,
and the left and right
torque arm assemblies
tightly to the exten-
sion. Thread the other
10
Get parts online at www.fusiondrillpowered.com or call 800-345-6007 M-F 8:00am-4:30pm CST.
FIGURE 4
Q
D
F
J
B
FIGURE 2
N
M
FIGURE 3
O
Locator
Stud
Drill-Powered Cultivator
Model Number:
C
L
K
E
R
P
33061
A