6. Secure the handle (O) to the transmis-
sion assembly using hand knob nut (D)
hand tightened firmly onto bolt (H).
SEE FIGURE 7
CAUTION: Because the left and
right torque arms are not used in
the shortened kneeling configura-
tion, two hands must always be used
when operating the cultivator. One
hand on the drill and the other hand
on the handle. Failure to do so will
result in loss of control of the tool.
To convert from kneeling to standing
configurations, simply reverse the pre-
vious steps. Always check to ensure all
components are attached according to
assembly instructions in this manual and
all hardware is securely fastened.
MAINTENANCE &
STORAGE
STEPS FOR WORKING
\
ON EQUIPMENT
1. Turn off drill and remove from unit.
2. Replace or repair the part on the unit.
3. Check all parts that were repaired,
WARNING
PRACTICE SAFETY AT ALL TIMES. DRILL MUST BE TURNED OFF AND
REMOVED FROM UNIT BEFORE ATTEMPTING ANY MAINTENANCE OR
REPAIR.
TO PREVENT ACCIDENTAL STARTING, DO NOT STORE THE UNIT
WITH THE DRILL ATTACHED.
CHECK UNIT OFTEN FOR LOOSE NUTS, BOLTS, AND PINS. KEEP
THESE ITEMS TIGHTENED.
AN ADULT MUST ALWAYS DO MAINTENANCE AND REPAIR ON UNIT.
14
Get parts online at www.fusiondrillpowered.com or call 800-345-6007 M-F 8:00am-4:30pm CST.
Model Number:
or removed during repair, that they are
secure and fit correctly.
Note: All repair parts must come
from the factory. Never replace parts
that are not specifically designed for
the unit.
4. Reattach drill to unit.
STORAGE
When the unit is put in storage, follow
the steps below to make sure the culti-
vator is in good condition the following
season.
CULTIVATOR
Completely clean the cultivator.
Remove drill from cultivator. Remove all
dirt and debris from cultivator compo-
nents. Put the cultivator in a building that
has good ventilation.
DRILL
Store according to drill manufacturer's
recommendations.
TROUBLESHOOTING &
REPAIR
At Ardisam, we build quality and durabili-
ty into the design of our products; but no
Drill-Powered Cultivator
33061