Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Features
Top Panel
Channels
Note: The channels have essentially the same
controls with some minor variations between
Channels 1–4, 5/6–9/10, and 11/12. The three
different channel types are shown here.
1. Mic Input: Connect a microphone or line-level
device to these inputs with an XLR cable.
2. Line Input: Connect line-level devices to these
inputs with 1/4" (6.35mm) cables.
3. Insert: Use a standard 1/4" (6.35mm) TRS cable
to connect an external processor (such as a
compressor, limiter, external EQ unit, etc.) to this
jack. The signal will be taken after the channel's
gain control and returned before the channel's
EQ controls. The tip of the TRS connection is the
send, and the ring is the return.
4. Gain: Adjusts the channel audio level (pre-fader
and pre-EQ gain). Adjust this so that the Signal
LED lights up.
5. Peak LED: The LED will flash if the signal is
clipping. If this happens, decrease the setting of
the Gain knob.
6. Low Cut Filter: When this button is depressed,
that channel's audio will be sent through a 75
Hz low-frequency filter with a slope of 18 dB
per octave. This is useful for reducing low-
frequency noise when using microphones.
7. Compressor:
compression on the channel, applied by the
mixer's built-in compressor. The LED next to the
knob will light up when the compressor is on.
8. Hi EQ: Adjusts the high (treble) frequencies of
the channel.
9. Mid EQ: Adjusts the mid-range frequencies of
the channel.
10. Low EQ: Adjusts the low (bass) frequencies of
the channel.
11. Monitor Knob: Adjusts the pre-fader level of the
signal sent from that channel to the Monitor Mix,
whose level is controlled by the Monitor Fader.
4
Adjusts
the
amount
1
1
2
2
2
3
5
4
4
6
7
8
8
9
9
10
10
11
11
12
12
13
13
14
14
of
15
16
2
2
5
4
6
8
9
10
11
12
13
14
15
15
16
16
5
Publicité
Table des Matières
