Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
WARNING
washer, release the pressure in the trigger handle, and
unplug the pressure washer before performing main-
tenance.
WARNING
with recommended or equivalent replacement parts.
Using an incorrect or incompatible part might create a
hazard that could result in serious personal injury.
NOTICE
Check the physical condition of the
product prior to each use. Look for loose bolts, fluid
leaks, and other signs of wear. Replace all damaged
items. For replacement parts or assistance, contact
our customer service team.
To prolong the life of this product, follow the maintenance
instructions in this section. Contact customer service before
servicing any recall or warranty parts.
CLEANING THE PRESSURE WASHER
Do not store or operate your pressure washer in dirty, dusty,
or corrosive environments. Do not allow foreign materials
and debris to clog the vents on the unit.
NEVER clean the pressure washer with a garden hose.
Water can damage the pressure washer's electrical com-
ponents. If the unit needs to be cleaned, use a soft brush
and damp cloth to clean the exterior and use low pressure
air (no greater than 25 psi) to clean the vents.
Never use gasoline as a cleaning agent.
CLEANING THE NOZZLES
See Figure 18.
l Stop the pressure washer and turn the water faucet
completely off.
l Release the pressure in the trigger handle and unplug
the pressure washer.
l Remove the nozzle from the trigger handle.
l Use a nozzle cleaning tool or fine needle to clean debris
from the inside of the nozzle.
l Using a garden hose, back flush water through the nozzle.
l When the nozzle is clean, place it back on the lance or
in the nozzle storage area.
CLEANING THE WATER INLET SCREENS
See Figure 19.
The screens inside the garden hose adapter should be
cleaned periodically. Remove the screens, rinse them with
clean water, and place them back in the inlet.
STORAGE
NOTE: Use commercially available pump protectors to
extend the life of the pump. Follow the manufacturer's
instructions for use.
ALWAYS turn off the pressure
Replace damaged or worn items
FIG. 18
A - Nozzle cleaning tool
B - Turbo nozzle
FIG. 19
A
A - Water inlet
B - Screen
l Release the pressure in the trigger handle and unplug the
pressure washer. Wrap the cord around the cord retainer.
l Remove the garden hose and store it properly. Tilt the
pressure washer to allow excess water to drain from the
inlet.
l Remove all nozzles and place them in the nozzle storage
area.
l Disconnect the high pressure hose and wrap it around
the hose retainer.
l Disassemble the trigger handle and lance, and place them
in the trigger handle holsters.
l Store the pressure washer in a dry, covered location away
from extreme heat which could dry out the pump seals
and extreme cold which could cause freeze damage.
B
A
B
English | 17
Publicité
