Publicité
Les langues disponibles
Les langues disponibles
Battery pack specifications:
Model
Chemistry
9HB180LT
Lithium Ion
WARNING: for other technical data refer to the label of Battery pack 9HB180LT.
WARNING: to reduce the risk of injury or explosion, never burn or incinerate a tool's battery pack
even if it is damaged, dead or completely discharged. When burned, toxic fumes and materials are
created.
ASSEMBLE AND DISASSEMBLE BATTERY PACK
AWARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF
position.
In order to assemble the battery pack, push the clip and insert the battery pack in the tool till it is fixed.
In order to disassemble push the clip and extract the battery from the tool.
CHARGE THE BATTERY PACK
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of
charging station 9HC180LT before using.
WARNING: Charge Rupes 18V Li-ION Battery pack 9HB180LT only in the Rupes 18V Li-ION Battery
Charger 9HC180LT. Other types of batteries may cause personal injury and damage. This tool's
battery pack and charger are not compatible with NiCd or NiMH systems.
The battery pack(s) contained in the kit shall be charger before use. The provided battery is charged <30%.
In order to charge, connect the Li-Ion battery with a charging station 9HC180LT till the charging is completed.
Charge your battery tool when convenient for you and your job.
The Rupes Battery pack does not develop "memory" when charged after only a partial discharge.
It is not necessary to run down the battery tool pack before placing it on the charger.
Use the led Battery pack 9HB180LT level indication to determine when to charge the Rupes Battery pack.
POWER SUPPLY (PROVIDED OR OPTIONAL)
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of Power
Supply 9HP180LT before using.
WARNING: Voltage and power frequency must match the data displayed on the identification plate of
the 9HP180LT power supply. Make sure that tool is switched off before plug is connected.
ASSEMBLE AND DISASSEMBLE POWER SUPPLY
WARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF
position.
In order to assemble the power supply, push the clip and insert the power supply in the tool till it is fixed.
In order to disassemble, push the clip and extract the power supply from the tool.
STARTING AND STOPPING
Starting: Rotate the speed regulation knob (2) and set up the speed; Now the tool can be started by pressing the
START/STOP switch lever (3). The RPM can be adjusted by rotating the speed regulator knob (2).
Stopping: Release the lever for stop the tool; Rotate the speed regulation knob until position 0 and the tool will
have turned off.
WARNING: If a case of unusual vibration is present after a start of the tool, switch-off the tool
immediately and eliminate the fault.
WARNING: To reduce the risk of injury, turn the knob until OFF position (position 0) after any use.
8
Voltage
Capacity
18V
2.5 Ah
Energy
Weight
45 Wh
0.360±0.005 kg
Publicité
