Porter&Charles CI60V Instructions D'installation Et D'utilisation page 18

WIRING AND SAFETY OF BUILT-IN OVEN
The instructions given below must be followed without fail during wiring :
The earthing cable must be connected via the screw with the earthing mark. Supply cable
connection must be as shown in Figure 1. If there is no earthed outlet conforming to
regulations in the installation environment, call the Authorized Service immediately.
The earthed outlet must be in close vicinity of the appliance. Never use an extension cord.
The supply cable should not contact the product's hot surface.
In case of any damage to the supply cable, make sure to call the Authorized Service. The
cable must be replaced by the Authorized Service.
Faulty wiring may damage the appliance. Such damage will not be covered under the
warranty.
The Importer declares that it bears no responsibility whatsoever for any kind of damage
and loss arising from non compliance with safety requirements!
Wiring of the appliance must be performed by an Authorized Service Technician. The
appliance is designed to connect to 208-240V~ electricity. If the mains electricity is different
than the value given, call the Authorized Service immediately. The appliance is designed for
fixed connection to the mains. It is necessary that you install a double pole switch between
the product and the electricity supply (mains), with a minimum gap of 3 mm between the
switch contacts. (32Arated, delay function type).
BLACK
RED
16
GREEN