Klarstein 10046258 Mode D'emploi page 18

EN
18
WALL MOUNTING INSTRUCTIONS
Remove the 4 metal wall brackets
and the 4 metal screws for the wall
brackets from the bracket and attach
these brackets to the back of the unit.
Mark the positions of the four holes
to be drilled on the wall, and Drill the
holes with the drill bit. Make sure
the distance between each holes
is same as the round holes on the
brackets at back of the heater.
Insert the plastic rails
fitting into the holes.
Insert the metal screws
into the plastic rails.
Lift the heater, align the four
round holes on the brackets on the
back of the heater with the four
screws on the wall, and slide the
screw from position A to position
B by moving the heater slightly.