Matrix A50 Mode D'emploi page 57

A Open HARDWARE FOR STEP 4.
4
B Attach the REAR TOP CAP COVER (11) to the
UPPER ASSEMBLY (8) using 2 SCREWS (K).
C Attach the FRONT TOP CAP COVER (12) to the
UPPER ASSEMBLY (8) using 2 SCREWS (K).
Hardware For Step 4
Description Qty
K Screw 4
12 8 11 K
A50 SHOWN
A Open HARDWARE FOR STEP 5.
5
B Slide the UPPER DUAL ACTION ARM (13) onto the UPPER ASSEMBLY
(8) and attach using 1 FLAT WASHER (L) , 1 HANDLEBAR CAP
(14) and 1 BOLT (M). Torque settings: 64.5 Nm / 47.6 lb-ft.
C Attach inside LINK ARM COVER (15) to LINK ARM (16) using 1 SCREW (N).
D Slide LINK ARM (16) onto the lower DUAL ACTION ARM (17) and
attach using 1 BOLT (O) and tighten to 80 Nm / 59 lb-ft.
E Attach outside LINK ARM COVER (15) to LINK ARM
(17) using 2 SCREWS (P) and 1 SCREW (N).
F Repeat steps B–E on other side.
G Move frame off Styrofoam base and cardboard.
M L 13 8
14
P 15 17
16
N
O
N
Hardware For Step 5
Description Qty
L Flat Washer 2
M Bolt (20 mm) 2
N Screw (8 mm) 4
O Bolt (25 mm) 2
P Screw (12 mm) 4
57