Rinnai RL94i Manuel D'utilisation Et D'installation page 9

Using the Water Smart / Bath Fill Function
Overview
This function is exclusive to the BC-100V temperature
controller. The bath fill function allows the consumer
to fill a tub with a preset volume of water at a preset
temperature. This is done by pressing the bath fill
button on the BC-100V controller while no hot water is
flowing and then opening only the hot water tap. The
water heater will stop the hot water flow when the
preset volume has been reached. The hot water tap
should then be closed and the bath fill button pressed.
The temperature settings for the bath fill function are
limited to those in the table below.
Bath Fill Temperature Settings
ºF 98 100 102 104 106 108
ºC 37 38
ºF 110 112 114 116 118 120
ºC 43 44
Setting the Water Volume
The default volume is set to 25 gallons. The volume
can be set between 10 and 120 gallons.
1. Press the "Priority" button on the
temperature controller. The green
Priority light will glow indicating
that this controller is controlling
the temperature and that the
Rinnai water heater is ready to
supply hot water.
2. Press the "Water Smart Bath Fill"
button to set the water volume
and temperature.
3. Press the "Temp" ▲ or ▼ buttons
to obtain the desired temperature
setting.
Available
39 40 41 42
46 47 48 49
VB Series Indoor LS Manual
The bath fill function will not work
NOTICE
properly if it is connected to multiple
water heaters. The tub will overfill
Multiple
because the bath fill function is not
Water
able to measure the water volume
when connected to multiple water
Heaters
heaters.
If power is lost during the bath fill
NOTICE
function, the water heater will shut
down but the water will continue to
flow. When power returns, the water
shuts off and Error Code 03 appears
on the controller.
Power
If power is lost after the bath has filled
Loss
but before the bath fill function button
is de-selected, then the water will not
flow during the power loss or after the
power is returned. Once power
returns, close the hot water tap and
de-select the bath fill function. No
error code appears.
Do not use with single handle fixtures
NOTICE
that have anti-scald features built into
them. These fixtures allow a
Anti-scald
predetermined amount of cold water
Fixtures
which is not taken into account by the
bath fill function.
4. Press the "Water Vol."▲ or ▼
buttons to obtain the desired
water volume in gallons.
5. Press the "Water Smart Bath Fill"
button.
Be careful not to overfill the bath. An
NOTICE
average bath volume is 60 gallons.
When filling the bath using this
function for the first time:
To Prevent
•Monitor and remain by the bath while
Over Filling
the water is running.
•Use a low bath fill volume less than
25 gallons
9