JUNO JCF14024F5 Notice D'utilisation page 33

All manuals and user guides at all-guides.com
Problem
A symbol is shown in‐
stead of numbers on the
Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera‐
ture.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera‐
ture.
Water flows inside the refrig‐
erator.
Possible cause
Temperature sensor prob‐
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze is switch‐
ed on.
The Shopping is switched
on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
Solution
Contact the nearest Author‐
ised Service Centre (the cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "FastFreeze function".
Refer to "Shopping function".
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
33