Publicité
Les langues disponibles
Les langues disponibles
CLEANING AND MAINTAINING THE MILK SYSTEM
CLEANING THE MILK SYSTEM
Clean milk system after each use.
Place a tall glass (with capacity exceeding 190cc) under the
extraction nozzle.
Fill the milk tank with drinking water (level 2) and close the lid.
Open the milk system door.
Connect the milk tank to the milk system.
When in Ready to Use Mode, adjust the selector to the Cleaning position.
Button D and selector's side light is blue.
Press button D. It will start to flash with a blue light during extraction.
The lights on buttons A, B and C will go out.
The milk system cleaning process begins when hot water and steam
come out (approximately 25 seconds). And this process can not be
stopped.
Afterwards, only the steam comes out (approximately 25 seconds).
This process can be stopped by pressing any of the extraction buttons.
The machine stops automatically.
MAINTAINING THE MILK SYSTEM
When in Ready to Use Mode, turn off the machine by pressing
button B and C at the same time for more than 3 seconds.
Remove the milk tank carefully.
Detach all the parts of the milk tank.
Rinse carefully any traces of milk with clean water. Immerse all
parts in hot water with detergent for a few minutes.
Rinse with cold clean water and wipe with a clean cloth.
Wipe the inner bottom of the milk system.
The milk tank and its lid are dishwasher safe.
To avoid loss, please install all the parts in
place after maintenance.
Clean with
damp cloth.
— 54 —
EN
A
B
C
Turn Off
A
B
C
Publicité
