Télécharger Imprimer la page

Delta Q MINIMILKQOOL Manuel D'instructions page 55

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
MILK-BASED BEVERAGE
PROGRAMMING THE COFFEE/GALÃO - LATTE AMOUNT
When in Ready to Use Mode, the milk tank with enough milk is connected to the milk system.
Adjust the selector to the Galão - Latte position.
Button D and selector's side light is green.
Raise the lever to its full extent and insert a Delta Q coffee capsule in the
capsule housing hole, in accordance with the housing silhouette.
Completely lower the lever.
Place a glass of Galão - Latte under the extraction nozzle.
Hold the button D more than 3 seconds, and the button A, B and C blink.
Press the button D again, thus beginning the coffee extraction. When the
coffee reaches the desired amount, press the button D. The machine
memorises this coffee volume and will start extracting it until a new
programme is set.
Afterwards, the machine pre-heats (approximately 25 seconds).
When it reaches the right temperature, the milk extraction begins and
when the milk reaches the desired amount, press the button D again.
And it return to Ready to Use Mode.
The machine memorises this milk volume and will start extracting it until
a new programme is set.
If no button is pressed for 1 minute, the machine will return to Ready to
Use Mode and will memorise the last volume set.
If button D is not pressed to stop the extraction process, the machine
will automatically stop when it reaches approximately 220cc.
PROGRAMMING THE COFFEE/CAPPUCCINO AMOUNT
When in Ready to Use Mode, the milk tank with enough milk is connected to the milk system.
Adjust the selector to the Cappuccino position.
Button D and selector's side light is green.
The next steps are the same as for predefining a Galão - Latte.
The difference is the cappuccino starting as follows: first the milk foam
(the machine pre-heats for approximately 25 seconds. when it reaches
the right temperature, the milk foam extraction begins) and then the
coffee.
If button D is not pressed to stop the extraction process, the machine
will automatically stop when it reaches approximately 220cc.
— 53 —
EN
A
B
C
A
B
C

Publicité

loading