Publicité
Les langues disponibles
Les langues disponibles
SET UP & USE
WATER DRAINAGE FOR COOLING MODE
This air conditioner is equipped with auto water evaporation so the water
compartment would not typically fill in cooling or heating mode unless there is
high humidity. Water drainage will generally only be required at the end of the
season for these modes. (see START-END OF SEASON OPERATIONS).
NOTE: FULL TANK - When the water level reaches a predetermined level, the
"full tank" indicator light located on the control panel of the unit goes on.
If an error code appears on the display screen on the control panel "E2"
in COOL mode. The unit will have to be drained.
Intermittent Draining
• Unplug the unit from the power source. Carefully move the unit to a drain area
over your basement floor or drip pan (not included). Remove the bottom drain
cap.
• Let the water drain away and replace the drain
cap. Restart the machine until the error code E2.
If the error repeats, call for service.
NOTE: Be sure to reinstall the bottom drain plug
before using the unit.
Continuous Draining
• Unplug the unit from the power source. Remove the bottom drain cap. While
doing this operation some residual water may spill so have a drip pan (not
supplied) to collect the water.
• Connect the drain hose (supplied) as shown in the diagram. The water can be
continuously drained through the hose into a floor drain or drip tray.
•Turn on the unit.
Drain outlet
Drain hose
WAIT 3 MINUTES BEFORE RESUMING OPERATION
• After the unit has stopped, it cannot be restarted for 3 minutes. Operation will
automatically restart after 3 minutes.
ENGLISH
Drain cap
Page 21
Publicité
