Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Attach the top and bottom panels (#6) with M4 x 10
screws (Fig. 3.)
4.
Install 4 hook supports (#7) inside the cabinet to
support the shelf. The angled tab slides into the slots
along the inside edges of the side panels. Make sure
each support is at the same height (Fig. 4).
5.
Place the shelf (#8) on the supports. You may need to
angle the shelf to have it pass through the front
opening (Fig. 5).
6.
Push down on each shelf corner to confirm
the shelf is fully supported. If the shelf
wobbles or tilts, a support may be in the
wrong slot (Fig. 6).
7.
Tighten all the screws in the cabinet.
8.
Move the cabinet to the chosen location in
the room. Make sure the wall is capable of
supporting the weight of the fully loaded
cabinet.
9.
How you attach the cabinet to the wall depends on the
wall' s material.
Wood:
a.
Hold the open cabinet against the wall.
b.
Drive one screw into the wall through a hole in the
back panel. Do not tighten fully yet.
c.
Check the cabinet is level. Use a small bubble level
to check the level from side-to-side.
d.
Drive the second screw into the wood wall once the cabinet is
level.
e.
Fully tighten both screws.
Drywall or concrete:
f.
Hold the open cabinet against the wall.
g.
Check the cabinet is level. Use a small bubble level to check the
level from side-to-side.
h.
Mark the wall through each hole in the back panel.
Visit www.princessauto.com for more information
Single Door Wall Cabinet
9124140
Figure 4.
Figure 5.
Figure 6
5
Publicité
